
Important Safety Precautions
Copyright
2001 Phone: (614) 771-2718 RE-ACM
Vanner Inc. FAX: 614-771-4904 Owners/Installation Manual
4282 Reynolds Dr. www.vanner.com Rev 0.1a
Hilliard Ohio 43026 RE-ACM-Owners_Man_R01a.doc
11
INCORPORATED
INCORPORATEDINCORPORATED
INCORPORATED
4. Vanner recommends that all AC electrical wiring be performed by a licensed electrician or
a qualified technician to ensure compliance with all applicable national and local wiring regulations.
5.
To avoid a risk of fire and/or electrical shock, always verify wiring connections are
in good electrical condition. All external conductors must use proper wire size to avoid dangerous
overheating or diminished performance.
6.
If the AC Control Module has been dropped or damaged in any way, do not operate the
ACM until it has been verified to be safe by a qualified technician.
7.
To reduce the risk of electrical shock, always disconnect the AC connections using the
code required AC disconnects.
8.
The ACM must be properly grounded in accordance with local and national codes and
ordinances before operation. For most installations, the negative (ground) conductor should be
bonded to the grounding system at one and only one point in the system.
9.
It should be noted that only qualified service personnel should attempt to wire the ACM to
the Inverter/Charger, and/or the AC Grid.
10.
Always use service disconnects to break the circuit before attempting any kind of servicing
of the RE-4500. DO NOT attempt to service the unit while still actively connected to a power
source of any kind.
3.3 Explosive Gas Precautions
1. This equipment contains components, which tend to produce arcs or sparks. To
prevent fire or explosion, do not install in compartments containing batteries or flammable
materials, or in locations that require ignition protected equipment. This includes any space
containing batteries or gasoline-powered machinery, fuel tanks, or joints, fittings, or other
connections between components of the fuel system. Likewise Lead Acid Batteries produce
explosive vapors which can be dangerous. Batteries generate explosive gases during normal
battery operation.
3.4 Code Compliance
???
Vanner Model RE-4500 is certified by Underwriter’s Laboratory to meet UL listing 1741 for
Photovoltaic Systems, and complies with IEEE 929 and the National Electric Code Article 690, Solar
Photovoltaic Systems.
Comentários a estes Manuais