Vanner RE Series Manual de Instalação descarregar pdf (Página 15)

Component Identification and Description of Operation



2001 Phone: (614) 771-2718 RE-ACM

Vanner Inc. FAX: 614-771-4904 Owners/Installation Manual

4282 Reynolds Dr. www.vanner.com Rev 0.1a

Hilliard Ohio 43026 RE-ACM-Owners_Man_R01a.doc

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

F 5 Figure 4.0-4 AC Raceway Terminations

INVERTER

OUT

UTILITY

GENERATOR

GND

BACK

FRONT

RIGHT

LEFT

(6) Mounting Bolt Slots

(7) AC Selector Switches

This set of switches allow the selection of the AC source to which the Inverter will connect. It either sources from the AC

Generator or the AC Utility. There also is a Auto/Manual switch to allow the automatic starting of the generator by the RE-4500.

These two switches allow the RE-4500 to control the AC transfer relay contained in the RE-ACM.

Switching the Selector to “Manual” allows the user to manually select the AC source, while setting the selector to “Automatic”

allows the RE-4500 to select the Utility or AC Generator as it determines necessary.

When “Manual” is selected, the user can either select the AC Generator or Utility via the “Utility/Generator” switch. In the

“Automatic” setting, the “Utility/Generator” switch does not function.

(8) AC Disconnect

This switch disconnects the Inverter and the load from the AC source such as the utility or the generator.

(9) Inverter Bypass Circuit Breakers

These Circuit Breakers select whether the Loads are connected to the RE-4500 Inverter/Charger or whether the Inverter/Charger

is bypassed connecting the load to the Utility or AC Generator.

(10) AC Load Circuit Breakers

These breakers can either be single or double breakers to connect the loads on L1 and L2 to the Inverter

or AC source.

(11) Chassis Ground Tie Point

This compression terminal provides a tie point for tying the chassis to a common chassis ground.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Sem comentários

Vanner RE Series Manual de Instalação Página 15